| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Floor Pans | Rating: 
|
| Author | Post |
|---|
| Posted: 12-23-2005 03:58 am |
|
1st Post |
|
TXJH Member
|
I have access to a bending brake to form new sheet metal floor and trunk pans, but what gauge metal should I use? Some previous owner had gone crazy with a rivet gun installing pieces of sheet metal over the rusting originals. What a mess!
|
||||||||||||||
| |||||||||||||||
| Posted: 12-23-2005 01:39 pm |
|
2nd Post |
|
Judson Manning Member 
|
TXJH, I don't know what the stock thickness is, however, the SCCA madates a minimum of 0.060" for steel floorboards replacing non-metalic ones, and 0.080" for roll-cage mounting plates. This should get you in the ball-park. Judson
|
|||||||||||||
| ||||||||||||||
| Posted: 12-24-2005 05:35 pm |
|
3rd Post |
|
Tom Thomson Member
|
TX I could not find a good spot on the floor of 16971 to check but the driveshaft tunnel mikes .048 or 18 ga. I like Judson's idea better though, I think the original is too light. I believe that you will find that this is not press brake work as the originals appear to have been drawn. I think I remember new pans offered in the UK but I don't know where. Maybe another member can help. Tom
|
||||||||||||||
| |||||||||||||||
| Posted: 12-24-2005 07:07 pm |
|
4th Post |
|
Mitch Ware Member 
|
Martin Robey, http://www.martinrobey.com, is one place that sells new floor pans in the UK. Mitch Ware 1974 Jensen Healey JH5 #111119670 1971 Triumph TR6 #CC66950LO
|
|||||||||||||
| ||||||||||||||
| Current time is 02:00 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Floor Pans | Top |
