Home 

 Moderated by: Greg Fletcher  
AuthorPost
browndog9
Member
 

Joined: 09-18-2015
Location:  
Posts: 41
Status: 
Offline
So in the middle of covid, 2020, two of my buddies and I drove from Fort Worth to Prescott Arizona to buy a GT.
I have managed to get the original paint and dented hood back to acceptable condition.
I now going to try to fix two interior problems.
I pulled out the cigarette lighter and the casing for the lighter came out with it.
I hate to take apart the dash and would like alternatives to get the thing back together.
The glove box latches but the tumbler is missing. You can open it with a screwdriver but where can I get the tumbler ?
Any positive suggestions appreciated. Bill

browndog9
Member
 

Joined: 09-18-2015
Location:  
Posts: 41
Status: 
Offline
Just for the sake of completeness, I did manage to get the cigarette lighter back together while shedding a slight amount of blood.
I removed the cover of the hose and heater shield on the passenger side. Taking off the hose from heater to defrroster vent , I was able to maneuver my arm and hand to a spot I could grab it.
Now for the tumbler.

redracer
Member
 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
Sorry; I didn't catch this thread last year when it came out. Do you need an actual tumbler/lock for the glove box? (should use the same key as the door locks)
stay safe. bruce

browndog9
Member
 

Joined: 09-18-2015
Location:  
Posts: 41
Status: 
Offline
Yes. I will take a picture of what I have and let you decide what I need. And thanks for your advice on my JH in St. Louis. I hope to enjoy Georgia in June. Bill

browndog9
Member
 

Joined: 09-18-2015
Location:  
Posts: 41
Status: 
Offline
Redrqacer, that did not go as planned. Sorry to take so long but I think it would be best if I got the whole glovebox lock assembly with a key if you have one. PM me as fire as the logistics.

redracer
Member
 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
I don't have a GT whole glovebox lock assembly(the 2 GTs I stripped, only one had a lock and Frank Schwartz got that one a few years ago).
Did you unscrew the round front threaded part holding the lock on?(in order to remove the assembly through nthe back of the box front).
btw, if you click on my name and then profile, my email address is there. This is a better way to contact me.

browndog9
Member
 

Joined: 09-18-2015
Location:  
Posts: 41
Status: 
Offline
Thank you I will



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems