| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Water Ingress | Rate Topic |
| Author | Post |
|---|
| Posted: 10-09-2019 05:07 am |
|
1st Post |
|
pokeyjoe Member
|
I just bought a 74 and recently discovered that the floors under the carpet are wet (and rusty, of course). The documents in the glove box were dry, but they were wrinkled up like they had been wet in the past. I currently have the pedal box out (brake work) and will clean it all up and reseal it. Any common places for me to address for water ingress? I'm thinking the previous owner left it out in the rain (top down), but I want to make sure I get everything repaired. The floors (pans) are still solid. I'm going to treat them with POR15.
|
||||||||||||||
| |||||||||||||||
| Posted: 10-09-2019 02:12 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Pedal box is a major contributor to water ingress along with the seal at the top of the window and convertible top, after that it would be holes from rust or drilled from PO's. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 10-09-2019 02:14 pm |
|
3rd Post |
|
chrisl Member 
|
Have a good look around the battery box area too; mine had some leaks coming in from underneath it as water seemed to pool in/around that spot.
|
||||||||||||||
| |||||||||||||||
| Posted: 10-09-2019 02:36 pm |
|
4th Post |
|
pokeyjoe Member
|
Thanks, I'll check the battery box.
|
|||||||||||||
| ||||||||||||||
| Posted: 10-09-2019 06:42 pm |
|
5th Post |
|
redracer Member
|
Glad to see you're PORing the floors; get a can of the spray mix that has the flexible "hose" with the nozzle on the end to get into your rockers(KBS: https://www.kbs-coatings.com/Cavity-Coater.html ). POR & Mastercoat may have similar products. Be sure to remove the inner fender covers(there are five #2 pozidriv screws) i.e. the 2 covers BEHIND the front wheels and the 2 covers in FRONT of the rear wheels. Coat at least 6" up as well as the top of the rockers. I've seen POR patch up holes the size of a quarter--just be sure to put a good backing on if that's your way to go. best to your project, bruce/Red Racer
|
||||||||||||||
| |||||||||||||||
| Posted: 10-10-2019 06:43 am |
|
6th Post |
|
Tim Murphy Member 
|
The air intake for the heater in front of the windshield. Washing the car or a heavy rain will cause water to get into the vent and then leak into the drivers compartment. Main reason for the interior floors rusting IMO.
|
|||||||||||||
| ||||||||||||||
| Posted: 10-18-2019 04:19 pm |
|
7th Post |
|
noomg Member
|
Joe, The first thing I'd do is get rid of those damned rubber mats. If the car gets wet and you don't pull everything out to dry the water can sit under those mats for months even though the car seems dry. That's why the J-H in particular has a problem with rotted floor boards.
|
||||||||||||||
| |||||||||||||||
| Current time is 01:24 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Water Ingress | Top |
