| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| tunnel insulation | Rate Topic |
| Author | Post |
|---|
| Posted: 03-26-2018 02:56 am |
|
1st Post |
|
rbcnewfield Member
|
I am replacing some interior trim on my 73, it has the original rubber mats but there was nothing to insulate the trans tunnel? There a 2 brackets/guides? spot welded to the drivers side only? Any idea what they are for or what I should do before covering the tunnel with carpeting. Attachment: 73 J-H (7).JPG (Downloaded 79 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 03-26-2018 03:02 am |
|
2nd Post |
|
Screenplay Member
|
The bracket on the driver's side makes it quick and easy to center the console during assembly. But that's not from any official sources, just my $.02. I took mine off when I redid the interior so the carpet could fasten directly to the tunnel and not have that funky hollow underneath. Clinton
|
|||||||||||||
| ||||||||||||||
| Posted: 03-29-2018 02:26 pm |
|
3rd Post |
|
Ralph H Member 
|
the tabs hold a piece of 1/4 inch padded backing and the carpet. The carpet was glued to the backing and snug fit into place. I put a stick-on foil mat down on the tunnel first and then glued my carpet to the original backing and slipped it back in. The top edge is concealed by the centre console. I did not use the original padded backing elsewhere as it is a water trap and causes rust. hence the rotten floor in most original JH.
|
||||||||||||||
| |||||||||||||||
| Posted: 03-29-2018 03:00 pm |
|
4th Post |
|
rbcnewfield Member
|
Thanks, I really appreciate the information. Mark
|
|||||||||||||
| ||||||||||||||
| Current time is 03:58 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > tunnel insulation | Top |
