| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Replacement Shifter Boots? | Rate Topic |
| Author | Post |
|---|
| Posted: 07-13-2005 05:42 pm |
|
1st Post |
|
edward_davis Member 
|
Does anyone know where to get or how to make a replacement shifter boot? The leather boot on my 74 JH is holey in several places and allows some engine cooling air into the passenger compartment. It's not a problem with the top down, but when I have the top up, the smell can be somewhat oily.
|
||||||||||||||
| |||||||||||||||
| Posted: 07-13-2005 07:00 pm |
|
2nd Post |
|
Mark Rosenbaum Member 
|
The shift lever gaiter is a simple piece to make. All you need is a small amount of new vinyl (or other material) in the color of your choice, a decent sewing machine, and someone to operate it. First, you must undo the screws at the rear of the transmission console and lift the console up so you can gain access to bottom front of the console. Next, undo the screws holding the gaiter assembly in place, and remove the gaiter assembly from the car. Prise the original fabric from the D-shaped sheet metal ring at the bottom of the gaiter assembly. Next, split the sewn seams along the side, and at the top where it forms the tube for the tie. This will give you a flat piece that can be used as a pattern. Cut out the new fabric in the shape of the old, fold over and sew the ends of what will become the tube for the tie, insert the tie and sew the tube, then sew the main seam along the side. Attach the new gaiter to the D-shaped ring with contact cement, and once this has set, punch holes in the fabric for the mounting screws. Assembly, as they say, is the reverse of removal. Attachment: gaiter.jpg (Downloaded 71 times)
|
|||||||||||||
| ||||||||||||||
| Posted: 08-27-2005 12:14 am |
|
3rd Post |
|
oldfatjohn Guest
|
Ireplaced my 73 boot with one from a 89 mustang.it fit well and looks good
|
||||||||||||||
| |||||||||||||||
| Posted: 10-05-2005 06:38 pm |
|
4th Post |
|
edward_davis Member
|
Just a note to let folks know that Mark's directions worked perfectly. I got my wife to stitch them together, and my car is as good as new. All for about $7 outlay, and we have enough fabric to make two more sets if need be. Here is a picture: http://jhppg.com/gallery/1974-No-18713/DCP_1632
|
|||||||||||||
| ||||||||||||||
| Current time is 03:09 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Replacement Shifter Boots? | Top |
