| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Door panels Fit | Rating: 
|
| Author | Post |
|---|
| Posted: 09-08-2014 12:59 pm |
|
1st Post |
|
roland11a Member
|
Hi all I'm in the process of manufacturing new door trim panels for my JH. I've made new door cards with all the holes for the trim clips in the correct places, Made a template out of a piece of old wallpaper using a spare door and transferred it to a sheet of hard board. My problem is I don't have a usable original door card ( all rotted away) to see how close to the edge of the door the trim panel actually finishes. It doesn't seem right that the door seals seal onto the panel covering but the retaining lug holes seem very close to the edge. Also the wider top bolster needs to clear the seal otherwise the door won't close. I would appreciate it if anyone could supply some photo's of a good original door panel, on the door. I'd hate to get it wrong as I'm proposing to trim in leather to mach the seats I'm getting re-covered Thanks
|
||||||||||||||
| |||||||||||||||
| Posted: 09-10-2014 01:56 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
The door panels do in deed go up against the interior door seals, I can send a photo but wont be till next week. PM me your e-mail address if you need them. Last edited on 09-10-2014 01:59 pm by Brett Gibson JH5 20497 |
|||||||||||||
| ||||||||||||||
| Posted: 09-10-2014 02:51 pm |
|
3rd Post |
|
roland11a Member
|
Hi Brett Thanks, sent e mail
|
||||||||||||||
| |||||||||||||||
| Current time is 09:31 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Door panels Fit | Top |
