| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Door rattle | Rate Topic |
| Author | Post |
|---|
| Posted: 05-12-2009 06:51 pm |
|
1st Post |
|
mcguan.2 Member
|
I have a '73 Jensen that I recently brought back to life after sitting for a year and a half. It's driving pretty well, so now I'm starting to attack some of the less critical problems. Both the driver's and passenger's doors rattle when cruising around the city, as if they're only loosely latched. Upon inspection, it seems that the weatherstripping on both is split open lengthwise and basically completely "deflated". Could this account for the entire degree to which the doors wiggle when driving? Or maybe the U-bolt latch that attaches to the body is worn from years of use? Does anyone have any experience with this? And does Delta sell replacement weatherstripping? It seems to me that the weatherstripping alone wouldn't account for the entire problem, but it seems like there aren't even that many moving parts that I could blame.
|
||||||||||||||
| |||||||||||||||
| Posted: 05-12-2009 08:44 pm |
|
2nd Post |
|
Jensenman Member
|
Bad weatherstrips will definitely cause a door rattle. When the outside of the door is even with the rear fender, the weatherstrip should be contacting the outside of the door trim panel, they should be compressed and it should take a good bit of force to 'wiggle' the door. If the inner door panels are missing or have been cut too short (like homemade panels I have seen) so that they do not contact the weatherstrip, that will do it as well. If the door does not fit even with the fender, the striker (the U bolt you mentioned) should be adjusted inward. Warning: those are not held in place with Phillips screws, they are #3 'Posidrivs' and a Phillips will strip them quickly!
|
|||||||||||||
| ||||||||||||||
| Posted: 05-12-2009 08:49 pm |
|
3rd Post |
|
mcguan.2 Member
|
Thanks for the heads up. I'll look into all this. One more thing, on the interior weatherstrips, they sit on a long "bracket" that is connected to the body. Is it possible that this bracket has gotten bent inward over the years?
|
||||||||||||||
| |||||||||||||||
| Posted: 05-12-2009 10:56 pm |
|
4th Post |
|
Jensenman Member
|
That's the 'pinch weld' where the inner and outer body members are joined together. It's doubtful they are bent. It's easy to check, though; pull the weatherstrip off then see if the pinchweld is vertical. If so, then it's fine.
|
|||||||||||||
| ||||||||||||||
| Posted: 11-04-2010 10:08 pm |
|
5th Post |
|
mdutch Member 
|
Has anyone found a source for replacing the weatherstripping on the pinch-weld? Does it match up with any other vehicles or OEM mfg?
|
||||||||||||||
| |||||||||||||||
| Posted: 11-04-2010 11:41 pm |
|
6th Post |
|
JodyKerr Member 
|
Jim @ Delta sells Weatherstripping Looks good on my project car.
|
|||||||||||||
| ||||||||||||||
| Posted: 11-05-2010 02:04 pm |
|
7th Post |
|
Brett Gibson JH5 20497 Member
|
http://www.macgregorukcarparts.com/index.html These guy's are pretty good as well
|
||||||||||||||
| |||||||||||||||
| Current time is 12:06 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Door rattle | Top |
