| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Fuel tank installation | Rate Topic |
| Author | Post |
|---|
| Posted: 06-29-2006 07:49 pm |
|
1st Post |
|
scjensen Member
|
I am ready to install my tank after repair. There is a black rubber tube that I had not noticed when I pulled the tank. As you look at the tank, it is to the right. I goes through the floor of the trunk, but does not connect to anything, top or bottom. Can someone tell me what this is?
|
||||||||||||||
| |||||||||||||||
| Posted: 06-30-2006 02:03 am |
|
2nd Post |
|
Mark Rosenbaum Member 
|
I believe this is the vent hose for the fuel tank overflow valve. It goes through the trunk floor and then ends. On my car it's plumbed rearward, horizontally, and held in place with a brass P-clip. I don't suppose the end's position is important, provided vented fuel doesn't hit the rear end or suspension parts.
|
|||||||||||||
| ||||||||||||||
| Posted: 06-30-2006 01:32 pm |
|
3rd Post |
|
scjensen Member
|
Thanks, Greg. I think you're right. I was looking at it again last night and that makes sense.
|
||||||||||||||
| |||||||||||||||
| Current time is 02:52 am | |
| > Jensen Healey & Jensen GT Tech > Miscellaneous > Fuel tank installation | Top |
