View single post by RG
 Posted: 11-01-2010 02:45 am
PM Quote Reply Full Topic
RG

 

Joined: 09-27-2010
Location: Troy, New York USA
Posts: 13
Status: 
Offline
 I just bought a 1973, vin 13934 and set about preparing for a NY Inspection. The Hazard Light Switch had come apart so I replaced it with a good take-out from a 74 parts car. Even with the new switch the Hazards were still inoperative. I found that I did not have power to the switch. The 74's owner's manual noted that power for the hazards was supplied through a 25 amp fuse located under the dash. I searched and was unable to locate the fuse.

Is this the same on a 73?

Is this fuse an inline glass bus fuse or a fusable link? Or are the Hazards fused from the main (3) fuse block?

I am able to get the Hazards to work if I toggle the Hazard Switch on and activate the turn signal stalk to either position. I assume the power from the turn signals are back feeding the Hazards.

Thanks,

Rob