 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 11-07-2009 |
| Location: | State College, Pennsylvania USA |
| Posts: | 6 |
| Status: |
Offline
|
Greg - thanks for reviving a forgotten memory - we must be close in age...I too wrestled a Rover rear end brake job (1972 Rover 2000tc) for several hours - couldnt get the caliper piston to retract to fit new pads. Seems that to retract, the piston has to be rotated within the caliper hole (if you made this stuff up, no one would believe ya). Ah...the pre-Internet era...I had to track down a hard to come by manual.