View single post by Ron Earp

Posted: 07-05-2005 06:11 pm

Joined:	03-12-2005
Location:	Cary, North Carolina USA
Posts:	339
Status:	Offline

This steel stock tank in the JH is a nightmare. It is heavy, very heavy, and of course for most of us it is rusted heavily as well. I sealed mine, put baffles in it, and created two feeds for my pump setup. Outcome is fine, that is, it works.

However, I'm still not happy with it because of weight and the location of the weight, up high. I'm thinking about having the tank fabricated in aluminum with the same outside dimensions so that it will plug in as a replacement.

I might just do a one off, or, if there is interest I'll see about having a bunch of them made. I would suspect they'll cost around $300 each, or thereabouts, to be made from good 2mm or 3mm ally panel with holes and fittings. If anyone is interested then post here so I can gauge demand and see if it is worth the hassle.

Thanks much,

Ron