View single post by timeforwalkies
 Posted: 10-04-2010 06:20 am
PM Quote Reply Full Topic
timeforwalkies

 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
 This is a lightened stock flywheel.  Probably in the 16 pound range.  I'll get back on that when I get it.

Getting back.  Just weighed it and it is between 14 and 15 pounds.  Don't have an ounce scale, so that will have to do.

If you don't mind.  Where did you get the pressure plate and disk?

Thanks for the torque information.  Is this dry, or with lube?  Any tips on removal and install?

Just watched a great TV show called "Horsepower TV"  Usually about V8s, modifications and producst.  But on this particular show they talked about the difference in lubricants that can be used for torquing and why.  Good stuff.  Motor oil, and molly lub,  will not give the desired result if a lubricant is required.  While you might reach the desired torque, you may not have reached the correct clamping force or "stretch" as they call it.  They recommend a product called "ARP Ultra Torque Lube"  Reaches the correct torque and clamping force at the same time.  A bit hard to explain.

Either way, I recommend this show.

Last edited on 01-10-2011 06:19 pm by timeforwalkies