View single post by pbahr
 Posted: 10-04-2010 04:44 am
PM Quote Reply Full Topic
pbahr



Joined: 04-15-2005
Location: Phoenixville, Pennsylvania USA
Posts: 202
Status: 
Offline
 I can confirm that the thickness that Art presents are accurate.

The key to haveing the rotors machined is to go to a shop that knows what they are doing.  I've had a couple of rotors screwed up by jerks who don't know what they are doing.

For road use, I don't see any problems with machining down to the allowable minimum. 

If your rotors are really that bad, just buy a new set..........

YELODOG