 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-15-2005 |
| Location: | Phoenixville, Pennsylvania USA |
| Posts: | 202 |
| Status: |
Offline
|
I have 45's on YELODOG, but the engine is tricked out a bit. Weber setup is below. Don't know if these settings would work on a stock engine.
Pete
Displacement .......... 2.2 L
Size ........................... 45DCOE- 9
Choke.......................... 36
Main Fuel Jets ........... 135
Main Emulsion Tube ...... F3
Main Air Corrector ........ 180
Idle Jet ....................... 50F9
Starter Jet…………….. 60F5
Pump Jet ................... 45
Aux. Venturi .................. 5.0
Pump Discharge ....... ???
Accel Pump Jet…….. 45
Accel Pump Spring ... ???
Accel Pump Rod ....... ???
Needle Valve ............. ???
Float Level ................. ???
Fuel Pressure ............ 2.5 psi highway, 3.0 psi track. Set by regulator.
1. Cams: High performance, custom grind, by West Coast Cylinder Heads (Richard Reyman).
2. Compression: 11.1:1
3. Heads: Ported/Polished and flow matched.
4. Valves: 0.180 oversize.
5. Ignition: Electromotive HPV-1 (Crankfire)
6. Plug gap: 0.040 in
7. Timing:
• Idle: 5 deg
• 3000: 28 deg
• 8000: 30 deg
• Rev limit: 7000 rpm