View single post by Mark Rosenbaum
 Posted: 06-28-2005 08:51 pm
PM Quote Reply Full Topic
Mark Rosenbaum



Joined: 03-12-2005
Location: Kingman, Arizona USA
Posts: 532
Status: 
Offline
 No welding was required.  All the joints in the Delta system stay together with nothing more than heavy-duty U-clamps.  I torqued these (to 5-8 ft-lb IIRC) during installation and so far none have even started to loosen.

At the front, I used a coupler to slip over the rear of the Y pipe and the somewhat shortened front of the Delta input pipe.  A photo of this area is attached.  If this is similar to your sleeve, then you may be able to remove any pipe remnants from the rear of the sleeve, and slide the Delta input pipe right in.  An expander or reducer might also be necessary.

I'll caution that the rear edges of the chrome exhaust tips remain razor sharp even two years after installation.

Attachment: Exhaust front.jpg (Downloaded 113 times)