 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-16-2005 |
| Location: | Ormond Beach, Florida USA |
| Posts: | 97 |
| Status: |
Offline
|
you don't have anything else to do untill it cools off!
| View single post by Dan (Florida) | |||||||||||||
| Posted: 08-04-2010 05:34 pm |
|
||||||||||||
Dan (Florida)
|
I wouldnt swap out because of popping! You may get into something even worse. Find a weber tuning site and get familiar with the jetting system and then go looking for a lean cylinder. You probably have a low speed jet or two that is too small. Pull the plugs and look for a light grey color and correct that to a medium grey. Either buy larger jets or find a mech or machine shop with a jet drill set and drill out one size larger. I'll probably hear about that but it is quicker and cheaper, and you can always buy the correct jet later. Also check the jets for debris which can lean out a jet. you don't have anything else to do untill it cools off!
|
||||||||||||
|
| |||||||||||||