View single post by SpeedyMitch
 Posted: 05-12-2010 09:02 pm
PM Quote Reply Full Topic
SpeedyMitch



Joined: 12-17-2009
Location: Hailey, Idaho USA
Posts: 83
Status: 
Offline
I have a leak at the exhaust manifold. The few nuts I can get access to have all been somewhat loose. I'd like to properly torque all of the nuts and use a lock washer but how to get access?

From other posts it appears you can jack up the engine to widen the gap between the frame and engine block.

Do I need to loosen only the driver side motor mount or both?

Where to place the floor jack under the motor to make sure there is no damage?

Ultimately I expect to need to replace the exhaust manifold gasket but can't imagine how to get enough access to do so.

Any hints are greatly appreciated!

Speedy Mitch
Jensen-Healey Mk 1 12827