View single post by subwoofer

Posted: 05-12-2010 06:38 am

Quote

Full Topic

subwoofer

Joined:	04-01-2008
Location:	Sandefjord, Norway
Posts:	617
Status:	Offline

I think the weather (it was cold in the garage at the time - likely 35-40ºF) and the oil seal material teamed up against me. I usually install oil seals with a rubber mallet, gently tapping them in. In this case the material was so hard that I had to remove the end seal plate to install it, and after almost destroying one of the cam seals I installed it from the reverse side.

As you say, this could be the reason. Having difficulties driving the seal in, I stopped when the outer surface sat .040" or so below the face of the holder. Not all the way in, but obviously too far in.

I have a day off work tomorrow, will see if I can get the 'box out then. Already ordered a new seal from Greg, I'll need it for the other engine if this one can be salvaged so no loss anyway.

--
Joachim