 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-15-2005 |
| Location: | Phoenixville, Pennsylvania USA |
| Posts: | 202 |
| Status: |
Offline
|
I did this conversion to YELODOG last year.
The Tranny mount Crossmembers are the same.
This Tranny mounting Plate that goes under the tunnel must be moved. Four inches forward sounds like the right amount.
There is a Bushing which must be installed at the rear of the Shifter Assy. This is a round rubber-center item with male screw threads on each end - kinda like the Engine Mount, but smaller. It requires some filing on the Shifter to get the correct angle, and drilling a hole in the cabin side of the tunnel as Judson indicated. Wish I had photos, but I dont. This bushing keeps the Shifter Knob from "flopping".
If you need more info, email me off-line, and probably talk on the phone.