 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-10-2010 |
| Location: | |
| Posts: | 5 |
| Status: |
Offline
|
Attachment: MVC-008S.JPG (Downloaded 79 times)
| View single post by 907 heaven | |||||||||||||
| Posted: 04-06-2010 10:31 am |
|
||||||||||||
907 heaven
|
I can supply the trigger wheels; the alloy pullies are just the OEM Lotus pulley modified to accept the trigger wheel - you need to cut a small rebate on the rear of the pulley, I make the trigger wheel and pulley a slight interference fit. Then there are 3 small holes to drill and tap into the pulley - the trigger wheel is fixed with countersunk M4 screws - I also like to bond it to the pulley to be 100% sure it isn't going anywhere. It is simple stuff for an engineer. I can sell you a trigger wheel for £25 plus postage. I have two versions - one as shown and one with angled teeth, to allow for a sensor set at an angle like the photo below. Attachment: MVC-008S.JPG (Downloaded 79 times)
|
||||||||||||
|
| |||||||||||||