View single post by Mark Rosenbaum
 Posted: 06-19-2005 05:14 pm
PM Quote Reply Full Topic
Mark Rosenbaum



Joined: 03-12-2005
Location: Kingman, Arizona USA
Posts: 532
Status: 
Offline
 I ran across a web page describing an inexpensive home-made pressure brake bleeder, which may be of interest.   The address is  http://www.bmw-m.net/TechProc/bleeder.htm  .
 
I have not built one of these, but the article makes sense.  The only concern I'd have would be how the various plastics involved would interact with a non-silicone brake fluid, as normally only a few materials (such as EP and Viton) will resist the corrosive action of such fluids for prolonged periods.