View single post by Greg Fletcher
 Posted: 03-25-2010 10:26 pm
PM Quote Reply Full Topic
Greg Fletcher



Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 430
Status: 
Offline
 I had the entire housing on the bench when I did it, my guess is that it would considerably easier that way, but you may be able to remove the distributor and drive the pin out with a small punch. If you decide to remove the housing, you'll need to set the engine at TDC, loosen the timing belt and mark the bottom most position of the front of the ignition pulley.