 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 02-11-2009 |
| Location: | |
| Posts: | 80 |
| Status: |
Offline
|
Thanks in advance
John English
JHMKII 20175
| View single post by jdenglish | |||||||||||||
| Posted: 10-20-2009 11:29 pm |
|
||||||||||||
jdenglish
|
I have a CC bell housing that I have bolted to the engine. The run out on the rear face appears to be over .20 out. Compounding the problem is that there are no dowel pins on the engine side of the bell housing or on engine to align one to the other. There are however 2 dowels on the rear of the bell housing that align it to the transmission. These 2 dowel pins could form the basis of determining the alignment to the engine if there were some measurements from these pins to the center line of the pilot shaft. Has anyone conquered this problem? Thanks in advance John English JHMKII 20175
|
||||||||||||
|
| |||||||||||||