 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 05-15-2006 |
| Location: | Tempe, Arizona USA |
| Posts: | 217 |
| Status: |
Offline
|
Is the slack vertical or rotational? The steering shafts have a bunch of crap rubber bits in them that break down over time because of age, oil, heat, etc.
You may need a rebuilt steering shaft (http://www.jhps.com/Merchant2/merchant.mvc?Screen=PROD&Store_Code=jhps&Product_Code=STRS&Category_Code=SUS)
Outside of that, if it's still not clearing the rear cam area, then the engine is still not quite set correctly. The front motor mounts have ~3/4" or more "vertical" alignment possibilities. It sounds like the driver's front side is still not high enough.