View single post by jdenglish
 Posted: 07-21-2009 05:40 pm
PM Quote Reply Full Topic
jdenglish

 

Joined: 02-11-2009
Location:  
Posts: 80
Status: 
Offline
 I just received my replacement floor pans and seat rails from Delta.  Since there is virtually nothing left of the front to rear floor rail stiffener on either side, I'm wondering just where to cut particularly at the rear suspension attachments and not risk misaligning the whole thing. What materials to use to make the new stiffener.  I presume the replacement would be welded in place first and the floor pan welded to it. Spot welded or continuous?  How to keep the thing from rusting out again from underneath ?  What to put on the topsides..Dynamat, Ethefoam?
Thanks
John