View single post by Dakota123
 Posted: 06-27-2009 07:57 pm
PM Quote Reply Full Topic
Dakota123

 

Joined: 03-20-2009
Location: Colorado USA
Posts: 187
Status: 
Offline
 In the interest of closing this out (I'm sure everyone was waiting with baited breath) she did indeed pass... with flying colors, no less.

Significantly less than 200 ppm HC and less than 3% CO at both 1,000 rpms and 2500 rpms.  Actually, these numbers are so good that I'm left wondering if the test wasn't flawed, but I'll take it.

I did back the timing down to 2^BTDC, the lowest I could get on the fine adjust knob alone (brilliant thing, that knob), based on the advice of Tim Engle.  Otherwise, I left the mixture at best idle quality.