View single post by Jensenman
 Posted: 05-27-2009 02:55 am
PM Quote Reply Full Topic
Jensenman

 

Joined: 04-14-2005
Location: Columbia, South Carolina USA
Posts: 156
Status: 
Offline
 Progress so far: the rear axle and all suspension links are completed and installed, the clutch and throttle cable linkage and installation are complete, the pedal box has been modified to accept an RX7 master cylinder so now comes the fun part: installing the noisemaker!

Rear axle in place:



13B rotary viewed from the left. It needs to come back about an inch to get it right where I want it. I discovered that Engine Mount Plan A will not work, so I have to go with Plan B. Problem is, there was no Plan B. Oh, well.



Scads of room in the J-H engine bay. I seem to recall that Donald Healey wanted enough room to allow for a V8 at a later date. I believe it and I thank him.