 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-14-2005 |
| Location: | Columbia, South Carolina USA |
| Posts: | 156 |
| Status: |
Offline
|
| View single post by Jensenman | |||||||||||||
| Posted: 04-09-2009 02:49 pm |
|
||||||||||||
Jensenman
|
The #1 problem is the pickup is not properly 'phased'. It's not difficult, just a little tedious. 'Phasing' means that the rotor points to the contact in the cap at the same time that the shutter wheel slit is centered in the pickup. The pickup has to be slid on the mounting bracket to set this and it might take a few tries to get it right. If this is not done the ignition timing will be impossible to set properly.
|
||||||||||||
|
| |||||||||||||