 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-17-2005 |
| Location: | Hilton, New York USA |
| Posts: | 798 |
| Status: |
Offline
|
Brett
| View single post by Brett Gibson JH5 20497 | |||||||||||||
| Posted: 02-24-2009 10:23 pm |
|
||||||||||||
Brett Gibson JH5 20497
|
The outer race, or Cup, should be stationary in the hub, there are no bevels or ridges, the cup just press fits in until it is seated and should not move. If it moves as I said just knock afew dimples in the seating surface, it's possible to use a vice to press the cup in as long as you dont press against the surface the roller bearings run on. The inner race of the roller bearings on the shaft spindle should also be some what of a interferance fit as well, they should not turn on the spindle, again a couple of dimples on the spindle should hold them in place as well. Brett
|
||||||||||||
|
| |||||||||||||