View single post by frank12873
 Posted: 12-16-2008 10:55 pm
PM Quote Reply Full Topic
frank12873

 

Joined: 03-22-2005
Location:  
Posts: 30
Status: 
Offline
 I'm not sure that you'd exacuate as much of the oil blowing it out like that as you would dumping it out like I did. Seems like you'd get most of it out that way, though, and as I said, getting those darn bolts back in was a huge pain. Took forever to get 'em lined up with the holes and started.

Hmmmm... I wonder if it's possible to thread the bolts in from underneath, then fit the cooler onto the "studs" and put nuts on top to secure it.....would be much easier to get a nut on a visible bolt that a bolt in an invisible hole...