View single post by John Kimbrough
 Posted: 10-22-2008 03:57 pm
PM Quote Reply Full Topic
John Kimbrough

 

Joined: 03-12-2005
Location: Washington USA
Posts: 116
Status: 
Offline
 As you said Joachim, it was a makeshift press rig.  Although I cannot remember the dimensions, I used materials on hand.  The receiving end was a threaded pipe connector, and the press end was a large socket of the right diameter.  A few large washers, and in my case a large hole saw, to make up the ends, and then a bolt to run all the way through.  Even at that it was a bear pressing it out.  Good luck.  John.