 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-01-2008 |
| Location: | Sandefjord, Norway |
| Posts: | 617 |
| Status: |
Offline
|
My rebuild is finally underway, pulled the right rear corner apart yesterday, no real problems. The old bushings are completely done, so I reckon I'll get a real improvement in handling once I'm done!
Now for todays question: Any tricks for getting the old bushing out of the upper rear mount point (the one on the bell housing)? I was not planning on detaching the drive shaft for this job, but the old bushings seem rather stuck.
I saw that John made himself a makeshift press tool, what dimensions did you use for that, John?
--
Joachim