 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-02-2008 |
| Location: | Manteca, California USA |
| Posts: | 17 |
| Status: |
Offline
|
I just completed my front suspension rebuild and sub-frame replacement. I used two axle stands and a 4X4 piece of wood about 18" / 46mm long cut to match the slope of the oil pan (sump) relative to the placement of the 4X4 on top of the axle stands. I had no problems with this set-up. It also helped with jack placement when I installed the sub-frame. I used advice from club archives and from John Kimbroughs torque settings sheet which saved a lot of time and worry. Good luck on your project!
Bill Nunes
#14592