View single post by Brett Gibson JH5 20497
 Posted: 08-19-2008 12:14 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497

 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 I have seen the belt run on both the front and back sides of the pulley's, dont recall seeing one run in the center, but I would'nt rule it out, I believe one cause of were the belt runs is wether it is running on the front or back side of the tensioner.

What I mean by that is, the belt runs clockwise, so the best position for the tensioner is running on the up side of the belt, easier to set tension, but it also can run on the back side, a bit more difficult to set but can be done. probably not saying this well but I hope it's not to cloudy, anyhow as long as it stay's put and you have decent tension I would'nt worry about it.

Brett