View single post by rossjfox
 Posted: 06-19-2008 03:24 am
PM Quote Reply Full Topic
rossjfox

 

Joined: 05-19-2008
Location: Montville, New Jersey USA
Posts: 56
Status: 
Offline
 Newbie here.  Redoing the wood on my dash board with a set from Madera Concepts.

To save me time and a lot of head scratching, can someone give me a few pointers as to how these panels are removed?  My car is a 75 JH5 with the real wood panels, not the vaneer.

Just poking around, it seems some knobs are difficult to remove.  I can't figure out how to get the panel light dimmer switch out.  Do I just pull the knob really hard to get it off and allow the switch to come out the back?  Also the choke knob seems to suffer the same problem.

What about that little panel by the ash tray?  Is it just glued down?

Any advice would be helpful.  Thanks in advance.

Ross