View single post by Bob McDonald
 Posted: 06-02-2008 08:36 pm
PM Quote Reply Full Topic
Bob McDonald

 

Joined: 05-30-2008
Location:  
Posts: 6
Status: 
Offline
 Hi Joel

I wrote out what I've done and sent it to Greg but I didn't have any photos

so it was probably hard to follow and I didn't keep my measurements.

All I can tell you is I milled a 4 speed bellhousing down and routered out

a 5/8" aluminum plate to match the mustang 4cyl transmission

Then stood a spare engine on end with the cut bellhousing pointing up

then installed the transmission and plate ,centering the input shaft to the crank

Tack welded the plate to the bellhousing and removing to weld completey

so if you measure everything from stock it is possible to make yourself.

Bob