View single post by Brett Gibson JH5 20497
 Posted: 04-22-2008 05:30 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497

 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 #1, Heat the studs, be very carefull to stay away from the block,

#2, if its stuck closed, dont bother with it, you dont need them anyhow, if you must, tap it out from the bottom side, use the largest punch you can because you will be tapping against the rubber seal surface, make sure the linkage arm assy. is taken off first.

#3, numbers are usaully on the outside of barrel, needs to be out to be seen.

#4, needel valve, mixture screw??? if the threads and taper are fine no reson to, if the taper is mared, then yes.

#5,