 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-08-2006 |
| Location: | |
| Posts: | 123 |
| Status: |
Offline
|
Have a nice day
Steve
| View single post by smcmanus | |||||||||||||
| Posted: 03-10-2008 09:33 pm |
|
||||||||||||
smcmanus
|
These seals do not seal in the bore of the rotor. They are about 1/16 inch smaller in diameter than the ID of the rotor. I called Delta for guidance and they told me this was correct. Can someone explain to me how these are supposed to hold the grease in the hub? Meanwhile, I mic'd the rotor bore and the spindle and came up with about inch and a half IDand 2" OD for the seal which is a standard size. I'll have those seals in the AM and see if they work. Have a nice day Steve
|
||||||||||||
|
| |||||||||||||