 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 12-07-2006 |
| Location: | |
| Posts: | 11 |
| Status: |
Offline
|
Anyone have any ideas on a fix?
| View single post by j4jacob | |||||||||||||
| Posted: 02-09-2008 05:12 pm |
|
||||||||||||
j4jacob
|
I've replaced the oil seal o-ring on the distributor shaft and it still leaks. Both breather tubes that vent to the cold air box are unobstructed so I don't think I have crankcase pressure issues (although the larger of the two is attached to some sort of solenoid in the cold air box and I;m not sure how this works). The spec o-ring seems loose. Maybe a slightly thicker seal would work but I haven't found one using the trial and error method. Anyone have any ideas on a fix?
|
||||||||||||
|
| |||||||||||||