 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 11-01-2006 |
| Location: | Glasgow, Scotland, United Kingdom |
| Posts: | 34 |
| Status: |
Offline
|
I used my OEM 4 speed x-member. Its perfect. I didn't drill new holes, but welded a plate on the base of the OEM 4 speed x-member, fitted it to the existing 4 bolts and the W58. Not the best solution, but it works (plate was 6 cm wide, 1 cm thick and i believe 9 cm long) as the plate will bend albeit a little. Best solution is to drill new 4 holes right underneath the rubber mount.
Sounds good. DO you have a photo you could post?
Thanks.
James