View single post by pbahr
 Posted: 08-25-2007 04:30 am
PM Quote Reply Full Topic
pbahr



Joined: 04-15-2005
Location: Phoenixville, Pennsylvania USA
Posts: 202
Status: 
Offline
 OK Steve, here is the pix of the Lever properly positioned in the Bellhousing hole.  It should be towards the fromt of the hole so it matches the off-set in the Grommet - Lever Slot.  I did a lot of layout work on these parts during design of the new rubber Boot (Grommet - Lever Slot).

BTW, the Pivot - Release Lever part numbers are:

4spd - 91526

5spd - 97353

These must be of different lengths because one of the Bellhousings is much longer than the other.

Pete

Attachment: Clutch Cable end - YELODOG lite.jpg (Downloaded 87 times)