 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-15-2005 |
| Location: | Phoenixville, Pennsylvania USA |
| Posts: | 202 |
| Status: |
Offline
|
I sent you a PM with a lot of details, but bottom line is that I think someone switched Pivot - Release Lever on your Bellhousing. They are different on the 4spd and 5 spd Tranny. Key to this system working properly is that the Ball on this part is 4 inches from the open end of the Bellhousing as shown on the sketch.
I'll post another reply with a pix of the lever in the correct position, cause I have not figured out how to attach more than one pix.......
Pete Bahr
Attachment: Clutch Pivot Ball dimensions lite.jpg (Downloaded 264 times)