View single post by pbahr
 Posted: 08-21-2007 07:21 pm
PM Quote Reply Full Topic
pbahr



Joined: 04-15-2005
Location: Phoenixville, Pennsylvania USA
Posts: 202
Status: 
Offline
 Steve,

Not sure what dimension you are looking for "face of the bell housing to the second lock nut?"

As Greg tells it, there are only two spots where things can go wrong.  You seem to recigonize these as well.

There might also be a problem where the Cable is attached to the Clutch Pedal, or where that end of the Cable Shield is anchored.

Also, when the Lever is positioned to just ready to press the Clutch fingers, the Lever is NOT centered in the rectangular Bellhousing opening - it is towards one end of it - see 2. below.

When properly installed:

  1. The Lever (rounded side, bottom of the "U") is about 1 1/8 inch from the inside of the rectangular hole in the Bellhousing.
  2. You should have about 1 1/2 inches of thread left on the Cable end, with a stack-up underneath it of two nuts, one thin washer and the Nylon Pad.
If you need any pix of this, I have a setup on the bench.  Just ask via a direct email.

Pete Bahr