 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-16-2005 |
| Location: | Ormond Beach, Florida USA |
| Posts: | 97 |
| Status: |
Offline
|
hth Dan
| View single post by Dan (Florida) | |||||||||||||
| Posted: 08-01-2007 11:22 am |
|
||||||||||||
Dan (Florida)
|
check the little pipe that goes into the side of the unysin to make sure it isn't blocked. I had one once that was with worse results than that. I think that it's also a good idea to blip the throttle with the air cleaners off and watch both slides to see if they move the same. With both carbs adjacent you can observe quite a bit even without a unysin. hth Dan
|
||||||||||||
|
| |||||||||||||