 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-06-2005 |
| Location: | Malone, New York USA |
| Posts: | 94 |
| Status: |
Offline
|
Have you put in the shims or a bushing around each mounting bolt yet? I think this would give you the correct hight, and not cause clearance issues with the shifter shaft. Calculations indicate a 0.5in. bush might just about be right. Also the bolts supplied by Delta would not be long enough, and have to be replaced by a set, a half inch longer.