View single post by jensenjoe
 Posted: 07-16-2007 12:20 pm
PM Quote Reply Full Topic
jensenjoe



Joined: 06-03-2006
Location: Sterling Heights, Michigan USA
Posts: 4
Status: 
Offline
 My first undertaking was with the intake cover. I got rid of the cam head imperfections using a file and then seated the gasket dry. This seems to work so far. WOO HOO HOO! ...but only time will really determine its grace.

I filed just enough to get rid of the really bad spots and then smoothed out a few other spots that looked like they could use it. Then the cover was torqued down to just where the gasket started to sqeeze out.

Now it's on to the exhaust side. Hope this goes just as smooth. I will keep you all posted on the progess.

Thanks for all the helpful comments!

Joe