View single post by smcmanus
 Posted: 05-16-2007 04:30 pm
PM Quote Reply Full Topic
smcmanus



Joined: 03-08-2006
Location:  
Posts: 123
Status: 
Offline
 Rainy day today so I had a chance to fiddle with the carbs.  I was able to balance them out then I tried to set the mixture.  I'm able to get the front carb set pretty good, but the rear carb is too lean.  I've cranked the needle CW quite a bit and the little washer is recessed up into the vacuum valve but still too lean.  Am I missing something obvious?  Any suggestions?

Thanks

Steve