View single post by Mark Rosenbaum
 Posted: 04-29-2007 05:26 am
PM Quote Reply Full Topic
Mark Rosenbaum



Joined: 03-12-2005
Location: Kingman, Arizona USA
Posts: 532
Status: 
Offline
 Normally that function is handled by a set of contacts within the starter solenoid.  There should be a white-yellow wire from the solenoid that runs to (a) one end of the ballast and (b) to the [+] terminal on the coil.

The solenoid's function here can be tested by unplugging the wire from the ballast and seeing if +12 volts appears on the wire end during cranking.  If not, and if the wiring is properly in place, then the solenoid would seem at fault.

Attachment: solenoid wiring.jpg (Downloaded 55 times)