 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-18-2005 |
| Location: | El Paso, Texas USA |
| Posts: | 159 |
| Status: |
Offline
|
Last edited on 04-22-2007 10:10 pm by Dan Eiland
| View single post by Dan Eiland | |||||||||||||
| Posted: 04-22-2007 10:09 pm |
|
||||||||||||
Dan Eiland
|
I'm about to do a final installation of my cam housings and was wondering about how the engine is set up for this process? If I understand the book correctly I need to set the timing so the number one piston is at TDC and then I can install the cam housings as long as the cam gears timing marks are aligned. Can someone confirm this or let me know how this is done without damaging any valves? Last edited on 04-22-2007 10:10 pm by Dan Eiland |
||||||||||||
|
| |||||||||||||