View single post by smcmanus
 Posted: 04-20-2007 02:06 am
PM Quote Reply Full Topic
smcmanus



Joined: 03-08-2006
Location:  
Posts: 123
Status: 
Offline
 I found the reason my temp guage doesn't work; there is no wire connected to the sending unit.  I then found a bundle of 2 whitish wires coming out of the harness close to the firewall that aren't connected to anything.  I tried hooking each of them to the sending unit, but still no temp reading.  There is also a black wire under the manifold that isn't hooked to anything, which I didn't try yet.  I'm not sure it will reach the sending unit.  So does anyone know which wire goes to what?  I looked but didn't find an answer in the service manual.

Thanks

Steve